# Current-powered cable boat > A boat that winds itself upstream with the river's own force - Date: c. 1440 - Era: Middle Ages - Domain: [Ships & Navigation](https://lastcodex.org/en/domains/navigation/) - Rebuild stage: III (Crafts & cities) - Difficulty: 3/5 - URL: https://lastcodex.org/en/inventions/current-powered-cable-boat/ A current-powered cable boat uses the river itself to travel upstream. Paddle wheels hung over its sides are turned by the current, and their shaft winds in a rope anchored upstream, so the boat hauls itself against the flow. The Sienese engineer Mariano di Jacopo, called Taccola, sketched such boats in manuscripts of the 1430s and 1440s, and French authors of the 1820s published theories of the aquamoteur. A related craft, the reaction ferry, crosses a river on a cable using the current alone. ![Current-powered cable boat · A boat that winds itself upstream with the river's own force](https://lastcodex.org/_astro/plate.UVp95yiE_ZUwKoq.webp) ## Legend 1. Hull 2. Paddle wheels 3. Winding shaft 4. Rope to the upstream anchor 5. Trailing float ## What it is A boat going up a river must overcome the current, by rowing, sailing, or being towed from the bank by men or horses. A current-powered cable boat takes its power from the current it is fighting. Over each side of the hull hangs a paddle wheel, like the wheel of a floating mill, and both wheels are fixed to one shaft across the boat. A long [rope](/en/inventions/rope/) is anchored upstream, for instance to another rope stretched across the river, and is wound several times round the shaft. The current turns the wheels, the shaft winds in the rope, and the boat pulls itself towards the anchor. The free end of the rope leaves the shaft on the downstream side and trails behind the boat, where a small float keeps it taut. ## How it works ![A wooden post with a rope wound four times round it: on one side the rope runs taut to a heavy sack of stones on the grass, on the other a hand holds the free end](https://lastcodex.org/_astro/v1.DBu3HsR3_199JaQ.webp) _A rope wound several times round a post holds a heavy load while a light pull is kept on its free end._ The lower blades of each wheel dip into the river, and the current pushes them downstream, as it pushes the blades of an undershot [water wheel](/en/inventions/water-wheel/). The wheels turn the shaft, and the rope from the anchor, which comes onto the underside of the shaft, is wound in. A rope wound several turns round a shaft does not slip when its free end is held with a small pull, which is why the free end trails to a float that the current drags downstream. In Taccola's version without a float, the boatman pulled on the free end. The current pushes on the hull as well as on the wheels, and it tries to carry the boat downstream. The boat moves upstream because the wheels are much larger than the shaft. Like a long lever, a wheel of large radius turning a shaft of small radius multiplies the force of the water on its blades, so that the pull on the rope can exceed the drag of the current on the hull. The boat gains force at the cost of speed: for every turn of the wheels it gains only the length of rope that one turn of the shaft takes in, and it creeps upstream far more slowly than the water flows. ## How to do it A model in a rain gutter shows a boat climbing against a flow of water with the flow's own power. You need a length of plastic rain gutter about 1.5 m long with end caps, a garden hose, a block of polystyrene about 10 cm by 6 cm by 3 cm, a wooden skewer, two plastic bottle caps, stiff plastic cut from a bottle, strong thread, a drawing pin, a small cork, glue, scissors, a craft knife, and an adult to help. ![The model: a length of gutter with water in it, capped at its upstream end and open at its downstream end, where the water spills into an earthenware basin; a small foam boat with a rectangular hole cut through it, a skewer spanning the hole with a paddle wheel of bottle cap and plastic blades on each side of the hull, and a thread attached to the end cap and wound several times round the bare skewer in the hole, its free end trailing to a cork float downstream](https://lastcodex.org/_astro/v2.Bh20WJxG_ZjTtwa.webp) _The flowing water turns the wheels, and the skewer winds the thread in, pulling the boat upstream._ Make two paddle wheels by gluing six small plastic blades, about 2 cm by 2 cm, round the edge of each bottle cap. Near the front of the block, cut a slot right through it from top to bottom, about 3 cm across and 1.5 cm long, so that 1.5 cm of foam is left on each side. Push the skewer across the block through both sides so that it spans the slot and turns freely, and fix a wheel on each end so that the lower blades dip into the water when the block floats. Lay the gutter outdoors on the ground with a very slight slope, remove the lower end cap, and let the hose run gently into the upper end. Fix the thread to the upper end cap with the drawing pin, lead it under the front of the boat and up into the slot, and wind it four times round the bare skewer there, so that the thread from upstream comes onto the underside. Let the free end drop back out of the slot and tie the cork to it so that it trails downstream. Set the boat in the water: the current turns the wheels and the boat inches upstream. If it slides back, turn the hose up a little or make the blades larger. ## History and evolution ![A flat ferry boat on a river, tied by two ropes to a pulley that runs on a cable stretched between posts on the two banks, its hull set at an angle to the current so that the water pushes it across](https://lastcodex.org/_astro/v3.CxCvC3xq_Z1INlTR.webp) _A reaction ferry crosses on a cable, its hull set at an angle so that the current pushes it towards the far bank._ The Sienese engineer Mariano di Jacopo, known as Taccola, drew boats that wind themselves upstream with the current. In one drawing a rope stretched across the river upstream holds a second rope that is led to the boat and wound round the shaft of its paddle wheels; in another, a float tied to the rope behind the boat keeps it taut. Franz Maria Feldhaus and Massimo Corradi both date these drawings to the 1430s and 1440s. Feldhaus also saw the same idea in a drawing of a boat with side wheels in Konrad Kyeser's Bellifortis of about 1405, while Corradi describes Kyeser's wheels as worked by men through a crankshaft. The idea was taken up again in France as the aquamoteur, a boat driven up rivers by the current alone, and French authors of the 1820s published theories and studies of such boats. A related craft uses the current to cross a river. Around 1511–1513 Leonardo da Vinci drew a ferry carrying oxen across the Adda at Vaprio, near Milan. Such reaction ferries hang from a cable stretched across the river. The ferryman sets the hull at an angle to the current with the rudder; the water presses on the angled hull and rudder, the cable takes the part of that push that runs downstream, and the rest moves the ferry across. Turned the other way, the same current takes it back. A ferry of this kind still crosses the Adda between Imbersago and Villa d'Adda without an engine. ## Key facts - Early drawings: Taccola of Siena, manuscripts of the 1430s and 1440s - Power: The current, acting on paddle wheels much larger than the winding shaft - Aquamoteur theory: French books of the 1820s - Reaction ferry: Drawn on the Adda by Leonardo da Vinci about 1511–1513; one still crosses at Imbersago ## Requires - [Water Wheel](https://lastcodex.org/en/inventions/water-wheel/): A river turned into work (c. 300 BCE) - [Rope & Cordage](https://lastcodex.org/en/inventions/rope/): Twisted fibres that hold the world (46,000 years ago) - [Dugout canoe](https://lastcodex.org/en/inventions/dugout-canoe/): A boat hollowed from a single trunk (c. 8,000 BCE) ## Sources - [Ruhmesblätter der Technik von den Urerfindungen bis zur Gegenwart (1910), chapter Schiffe, pp. 399–401](https://archive.org/details/ruhmesbltterder00feldgoog), Franz Maria Feldhaus, Friedrich Brandstetter, Leipzig (Internet Archive) - [Boats propelled by paddle wheels and animal propulsion: a curious history](https://indico.atenanazionale.org/event/2/papers/193/files/302-FP_id06_Corradi.pdf), Massimo Corradi, Università di Genova - [Théorie des bateaux aqua-moteurs, propres à remonter les fleuves et à les descendre plus rapidement, par la seule action de leur courant (Lille, L. Danel, 1826)](https://bibliotheques-numeriques.defense.gouv.fr/impression/document/4f39af06-b877-4641-93e8-396eb3269ae5), Th. Barrois, catalogue record, Bibliothèques numériques de la Défense - [Essai sur les bateaux à vapeur appliqués à la navigation intérieure et maritime de l'Europe, sur les bateaux aqua-moteurs et particulièrement sur le touage par la vapeur (Paris, Malher, 1828–1829)](https://bibliotheques-numeriques.defense.gouv.fr/impression/document/20e9518e-51e2-47ae-9b91-58c951cacf57), A. T. Tourasse and F.-N. Mellet, catalogue record, Bibliothèques numériques de la Défense - [Leonardo da Vinci, A river landscape (The chain ferry at Vaprio d'Adda), c. 1511–13, RCIN 912400](https://col.rct.uk/collection/912400/a-river-landscape), Royal Collection Trust - [Italian commuters find a moment of peace on a cable-guided ferry sketched by Leonardo da Vinci](https://www.news4jax.com/news/world/2026/06/09/italian-commuters-find-a-moment-of-peace-on-a-cable-guided-ferry-sketched-by-leonardo-da-vinci/), Associated Press, 9 June 2026 - [C'è traffico, meglio prendere questo traghetto di cinquecento anni fa](https://www.ilpost.it/2026/05/15/traghetto-leonardo-imbersago-adda/), Isaia Invernizzi, Il Post, 15 May 2026 Fact-checked on 2026-10-21. --- The Last Codex · https://lastcodex.org/en/inventions/current-powered-cable-boat/ · © The Last Codex. Texts, plates and figures: CC BY-NC-ND 4.0.